Bounds refer to the physical features that define the lands boundaries. For example, the southwest corner of section 1 is also the southeast corner of section 2, as shown in the diagram below. Metes and bounds : Metes are the direction and distance of a line forming the boundary of the property. When searching for Corner Certificates, also search abutting sections or townships. A subdivision survey can be done using metes-and-bound system or lot-and-block subdivision but it mostly employs a metes-and-bounds system to delineate. ![]() When a survey or plat is made, proper recording of Corner Certificates is required, consisting of a minimum of two or more appropriate controlling government corner locations.Ĭorner Certificates can be searched by section number, township number and range number. A section is a parcel of land generally comprised of one square mile or 640 acres. Lot and Block, The method of describing land that uses degrees, feet, and monuments is known as the A. CornersĪ Certificate of Location of Government Corner, also known as a Corner Certificate, is a document developed by a licensed land surveyor to mark a corner within a section of land. Study with Quizlet and memorize flashcards containing terms like In describing real estate, the system that may use a property s physical features to determine boundaries and measurements is: A. If no survey is found by parcel number, search using the section, township and range option or by the city name. Parcel numbers are not entered on older surveys. Other times, a flawed metes and bounds description may leave out portions of a parcel so that it is beset with missing pieces or holes or it may. Searches can be done by document / survey number, location (section, township and range) or by parcel number. The Clay County Recorder's Office began filing surveys in 1991 when the county required a survey according to county ordinance. Instead of a metes and bounds description, a lot, block and name of a plat are used to describe the property once it is platted. Usually an owner of a tract of land chooses to plat the land so lots can be sold. Metes and bounds description is a way of describing a property that is not in a subdivision by using bearings and distances and may also use known attributes. PlatsĪ plat is a map of a tract of land subdivided into lots with streets and alleys drawn to scale showing dimensions. ![]() The system is often used to define larger pieces of property and political subdivisions where precise definition is not required or would be far too expensive, or previously designated boundaries can be incorporated into the description.Search, view and print plats, corners & surveys online. The term "bounds" refers to a more general boundary description, such as along a certain watercourse, a stone wall, an adjoining public road way, or an existing building. A direction may be a simple compass bearing, or a precise orientation determined by accurate survey methods. The term "metes" refers to a boundary defined by the measurement of each straight run, specified by a distance between the terminal points, and an orientation or direction. ![]() Metes and bounds is a system or method of describing land, real property (in contrast to personal property) or real estate. Metes and bounds are a method that starts at a point of reference, such as a river or a road and proceeds to describe the property in terms of compass directions and linear measurements. It builds upon previous methods and can be used to clearly identify properties in dense urban and suburban areas. It is often used in connection with the Government Survey System. Lot and block is the latest development in real estate survey methods. It is a way of describing land by listing the compass directions and distances of the boundaries. Metes and bounds are the boundary lines of land, with their terminal points and angles.
0 Comments
Leave a Reply. |